When the burlap was down, I measured the window from side to side including the moldings.
Everything settles and you’ll end up with little dips where the screws are if you try to get away with one coat, whether it’s thick or thin.Trust me, I have the dimply walls to prove it.
So now you’ve built a simple frame, attached a sheet of drywall, and filled in all the holes.Just a few simple steps and you’ve made a. whole wall!.All that’s left to do now is sand the small amount of excess mud (once it’s dry!)
and you’re ready to paint and prime..If you’ll be sanding by hand, you’ll be REALLY happy that you took my advice because your life will be so much easier with just this little bit of sanding to do.
If you’re using an electric sander, make sure you’re super gentle with your sanding.
I find it helps to use a really fine grit sand-paper that’s even a bit worn out to make sure I don’t overdo it..No duplicate comments.. You may receive (2) total entries by selecting from the following entry methods:.
Leave a comment in response to the.takes prompt on this post.
Tweet (public message) about this promotion; including exactly the following unique term in your tweet message: “#.takesEntry”; and leave the URL to that tweet in a comment on this post.