Allow the filter to dry for at least 24 hours before putting them back into the machine.
The V8 series has both washable pre-motor and post-motor filters though, so check your manual.. Gently tap off excess dust.This makes the filter easier to wash. You can also tap off dust from non-washable filters.. Rinse the filter with cold water.
The goal is to keep rinsing until the water runs clear.Some Dyson filters are tube shaped, so you can just run them under the tap.Others have a cup shape, so you’ll need to fill the filter with cold water, give it a small shake, tip out the dirty water, then repeat.
Remove excess water.Some Dyson filters can be gently wrung out to remove excess water, while others should just be tapped off into a sink.
Check the manual before wringing out a filter, as using this method can damage certain types of filter..
Allow the filter 24 hours to dry.Do you have any questions about how to remove hair from the Gtech Multi Mk2’s brush bar?
Please use the comments section below.You may also want to read our guide to.
emptying the Gtech Multi Mk2The Gtech Multi Mk2 has a washable filter that needs to be cleaned on a monthly basis.Here’s how to clean the filter and maintain your vacuum’s suction power..